Installing The Bottom Shelf; Adding Wheels To The Cart; Installing The Lid Handle - Pit Boss PRO Serie Assemblage Et Fonctionnement

2. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Bottom Shelf (#26)
4 x Screw (#A)
4 x Washer (#B)
4 x Locking Washer (#C)
Installation:
• Mount the Bottom Shelf to each Support Leg using a screw, locking
washer, and washer. Ensure the flat surface of the shelf is facing up
towards the Grill Barrel.

3. ADDING WHEELS TO THE CART

Parts Required:
2 x Locking Caster Wheels (#27)
2 x Wheel (#28)
2 x Wheel Cotter Pin (#E)
2 x Wheel Washer (#F)
2 x Wheel Axle Pin (#G)
Installation:
• Insert each Locking Caster Wheel into the bottom of each Left Support
Leg by hand-tightening into the hole. Ensure that each Locking Caster
Wheel is inserted completely. Note illustration 3A.
• Attach each Wheel to each Right Support Leg by inserting the Wheel
Axle Pin through the Wheel, Support Leg hole, Wheel Washer, then
secure using the Wheel Cotter Pin. Note illustration 3B.
• Once the shelf is secure, carefully lift the grill into an upright position.
IMPORTANT: Re-tighten the support leg screws to ensure they are
completely secure after positioning the grill upright.

4. INSTALLING THE LID HANDLE

Parts Required:
1 x Lid Handle (#11)
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside
the barrel lid, insert one screw to protrude to the outside, then hand-
tighten the screw (from the inside) into the Lid Handle. Repeat the same
installation for the other end of Lid Handle.
8
2
26
3A
23
27
27
3B
G
28
F
E
E
F
28
4
22
G
11