Control Board Functions - Pit Boss PRO Serie Assemblage Et Fonctionnement

CONTROL BOARD FUNCTIONS

• SETTING THE GRILL TEMPERATURE
The Grill Probe measures the internal temperature of the Main Barrel. When the Set temperature is adjusted, the Grill Probe
will read the Actual temperature inside the Main Barrel and adjust to the desired Set temperature.
IMPORTANT: The temperature of your unit is highly dependent on ambient outdoor weather, quality of pellets
used, flavor of pellets, and the quantity of food being cooked.
SETTING/ADJUSTING THE SET TEMPERATURE
To adjust the desired Set temperature of the grill, follow the steps below:
1. Press the Controller Knob. This will make the Set temperature readout blink, to show it is active.
2. Use the Controller Knob again to adjust to your desired temperature.
3. Once the desired Set temperature is reached, press the Controller Knob to confirm the Set temperature,
then the readout will return back to the Actual Temperature.
• USING THE PROGRAMMABLE MEAT PROBE
The meat probe measures the internal temperature of the meat on the grill, similar to your indoor oven. Insert the stainless-
steel meat probe into the thickest portion of the meat. The internal temperature of the meat is shown on the Control
Board readout. Plug-in the Meat Probe adapter to the meat probe connection port and ensure it is inserted all the way
into the plug. You will feel and hear it snap in place. Not only will it cook the meat to your desired temperature, but it will
automatically reduce your grill temperature to low (82°C / 180°F) to keep food warm until ready to serve. Just set it, then
relax while the Meat Probe does the rest!
NOTE: When placing the meat probe into your meat, ensure the meat probe and meat probe wires avoid direct
contact with flame or excess heat. This can result in damage to your meat probe. Run the excess wire out the rear
exhaust holes of the Main Barrel, the top of the Main Barrel (near the grill lid hinge), or through the front hole
near the hopper. When not in use, disconnect from the meat probe connection port, and place in the holes on the
hopper handle to keep protected and clean.
SETTING/ADJUSTING THE PROGRAMMABLE MEAT PROBE
To program the desired Set temperature of the Programmable Meat Probe, follow the steps below:
1. Quick press the MPC button to activate the Programmable Meat Probe. When active, the temperature
readout of the Meat Probe will blink.
2. Use the Controller Knob to adjust to the desired Set temperature.
3. Once the desired Set temperature of your selected Meat Probe is reached, press the Controller Knob
again to confirm and exit the Programmable Meat Probe settings.
18