Installing The Bottom Shelf; Securing Cart Front/Back Panel; Securing Cart Bar / Cylinder Support Bracket - Pit Boss SPORTSMAN PB1230SP Guide De Montage

2. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Cart Bottom Shelf (#18)
1 x Support Leg for Caster / Front (#13-1)
Support Leg for Caster / Back (#13-2)
1 x
Screw (#A)
4 x
4 x Washer (#B)
4 x Locking Washer (#C)
Installation:
• Attach the Bottom Shelf to one Support Leg by carefully aligning it into
the slotted corner of the Support Leg, then secure using one screw. Repeat
installation for the other three Support Legs to the remaining three
corners of the Bottom Shelf.
NOTE: Ensure the flat surface of the Bottom Shelf is facing up. There are
three holes in the bottom plate on one side of the big Wheel. Once the
bottom is installed incorrectly, the gas tank cannot be placed. Once the
shelf is secure, lift the cart frame into an upright position.

3. SECURING CART FRONT/BACK PANEL

Parts Required:
2 x Cart Front / Back Panel (#21)
8 x Screw (#H)
Installation:
• Install one Long Cart Plate to the front two Support Legs of the unit.
Secure using two screws on each side. Ensure the flat side of the Support
Plate is facing outwards. Repeat the same installation to mount the
other long Support Plate to the other Support Legs.

4. SECURING CART BAR / CYLINDER SUPPORT BRACKET

Parts Required:
Cart Bar A (#14)
2 x
Cart Bar B (#15)
2 x
1 x LP Gas Cylinder Support Bracket (#20)
3 x Screw (#A)
7 x Washer (#B)
Locking Washer (#C)
7 x
Screw (#I)
4 x
Installation:
• Screw the Cart Bar A and Cart Bar B to each Support Leg using a screw,
locking washer, and washer. Note illustration 4A.
• Secure the LP Gas Cylinder Support Bracket to the Cart Bottom Shelf using
three screws, locking washers, and washers. Note illustration 4B.
6
2
18
B
C
A
3
21
H
21
4A
14
15
4B
20
18
I
C
B
A
C
B