Preparing The Connection To The Flue - Dovre ROCK 350 Installation Et Mode D'emploi

4
1
8
11
10
Removable internal parts
01 left-hand rear inner plate
02 right-hand rear inner plate
03 centre rear inner plate
04 inner plate left
05 inner plate right
06 baffle plate
07 rear bottom of the fire
compartment
08 fire basket
09 front bottom of the fire
compartment
10 ash pan
11 ash removal port
Preparing the connection to
the flue
When connecting the appliance to the flue, you can
choose to connect to the top or to the rear of the appli-
ance
Connecting to the top
As standard, the appliance is delivered with the con-
nection collar fitted for a connection at the top, see fol-
lowing figure.
12
6
3 5
2
7
9
09-20021-153
13
Connecting to the back
For a connection to the rear, the position of the con-
nection collar needs to be changed. The connection
collar is attached with 2 M8 nuts (key 13). Proceed as
follows:
Disassembly (see previous drawing)
1. First remove the baffle plate.
2. Remove the cover (8) from the back wall by
removing the nut (13) and the clamping bracket
(12).
3. Remove the cover (8) and the seal (9).
Check that the sealing tape on the contact sur-
face is not damaged. Replace the sealing tape
if it is damaged.
4. Disassemble the connecting collar (3) by undoing
the bolts (2).
5. Remove the connection collar (3), the seal (4), the
materials supplied (2, 6, 7).
Check that the sealing tape on the contact
surface is not damaged. Replace the sealing
tape if it is damaged.
Subject to change because of technical improvements
1
2
3
4
6
7
10 9 8
12 11
09-20021-158