Annex: Insertable Tools - Meister basic BKB 135 E Traduction Du Manuel D'utilisation Original

5400630-Kleinbohrm-man 24.01.14 11:50 Seite 41
health. Appropriate safety measures are
required. Example: Some types of dust
are carcinogenic. Always wear a suitable
safety mask.
Tips
• Small hob cutters/point grinders: high
speed
• Large hob cutters/point grinders: low
speed
• For fine work, engraving etc. hold the
machine like a pen (fig. 4).
• For rougher work with the wire brush
etc. hold the machine like a hammer
shaft (fig. 5).
• When drilling, hold the machine
vertically downwards (fig. 6).
• The clamping shafts (c, e, g) (fig. 2)
(appendix) are easier to hold when
inserting the tools if they are pushed
into the hole in the universal wrench.
10 – Annex: Insertable tools
Cutting-off disks (b) and sanding
sheets (a) (Fig. 7)
For use in model-building and
electronics (motherboards).
To insert, use the clamping shaft (c) with
screw. Loosening and tightening of the
screw with the universal wrench (10).
Grinding cylinder (Fig. 8)
For fine grinding or sanding work on
rounded or small surfaces.
Slide grinding cylinder onto the cylinder
clamping shaft (e). When the retaining
All manuals and user guides at all-guides.com
screw is turned, the rubber bead is
expanded thereby holding the grinding
cylinder in position.
Polishing felt (f) (Fig. 9)
For use with standard polishing pastes
for fine polishing work, removal of
scratches from lacquered or plastic
surfaces etc.
To fit, screw the thread of the clamping
shaft (g) into the felt.
Point grinders (h) (Fig. 10)
For sharpening cutting tools and for
removing sharp edges from metal and
plastics.
Traces of wear on the grinders can be
compensated by using the grinding
block (14). This improves the concentric
running of the tool.
Drill (i) (Fig. 11)
For drilling small holes in watchmaking
and model making.
Brushes, metal and plastics (k) (Fig. 12)
• Metal:
• Plastics: For working non-ferrous
Diamond grinders (l) (Fig. 13)
For grinding and engraving hard materials
such as glass, ceramic, porcelain and
plastics. Diamond grinders suitable for
engraving and chasing glass.
Milling points (m) (Fig. 13)
For processing metals and plastics
For cleaning metals and
stone
metals
41