Hose Change - Truma CS Mode D'emploi

– Close the valve (1) of the empty gas cylinder (2).
– Remove the high-pressure hose (4) from the gas cylinder (2) and
remove the clip-on adapter, if present.
– Attach the high-pressure hose to the full gas cylinder and fit the clip-
on adapter, if present. Change the filter pad of the gas filter.
– Open the full gas cylinder's valve (1).
– Press the hose rupture protection (figure 1a – 3) and if necessary
the yellow reset button (7), turn it slightly clockwise and hold it for
5 seconds.
After any intervention, check the hose connection to the cylin-
der valve for leaks (see "Checking for leaks in the high-pressure
section").

Hose change

Use the included screw aid (11) to attach and remove the high-pres-
sure hose (4). It will help you generate the necessary tightening
torque and will prevent damage to the union that may otherwise re-
sult from using an improper tool.
Residual gas: No smoking, no naked flames!
– Close the gas cylinder valve (1).
– Unscrew the high-pressure hose (4) from the gas cylinder (2 / or the
clip-on adapter) and from the gas filter / MonoControl CS inlet.
EN
26