Procopi Delta STARDECK Notice D'installation Et De Maintenance page 56

PROGRAMMING THE ENDS OF TRAVEL
POSITIONING THE MOTOR PIT INVERTER:
The inverter will be switched to the right or left, depending on the position of AQUAMAT 3001 with
respect to the pool (see diagrams below):
Motor pit
Switch the inverter to the left
BEFORE PROGRAMMING THE ENDS OF TRAVEL:
- Check that the key switch is set to "0".
- Check that the motor pit inverter is correctly positioned
- Energise the control panel (the orange switch lights up).
PROGRAMMING THE ENDS OF TRAVEL:
- Simultaneously, press buttons 2 and 3 and hold them down for 3 seconds.
- Release them and then press button 1 briefly.
- The red LED on the control panel flashes until programming is complete. If the LED does
not flash, turn the panel off, then turn it on again and restart the programming procedure
from the beginning.
- Using the key switch, roll the cover out fully over the pool, stop when the first slat touches
the edge opposite the axle.
- Press briefly on button 2 to confirm the closed position. The LED continues to flash.
- Roll the cover up fully, stopping when the first slat is 10 cm under the water level. If the
cover is fitted with a step-piece (roman or square), stop when the cover is 10 cm behind
the last housing joist.
- Press and release button 3. The LED goes out. Programming is finished.
Check that the cover is working correctly by carrying out two full "open/close" cycles. The cover should stop on
its own at each end of travel.
AQUAMAT 3001 M
Cover pit
Pool
In the event of a power cut during programming (LED flashing) no
information is saved to memory.
Restart the programming procedure from the beginning.
OTOR
Cover pit
Pool
Switch the inverter to the right
CAUTION
56/76
2009/02 - Indice de révision : D - code : 0035431
Motor pit