Procopi Delta STARDECK Notice D'installation Et De Maintenance page 50

1
Using a screw driver, widen the groove of
1
the 'female' slat along a length of 5 cm.
4
Flatten out the assembly.
4
Installation of the counterweight on the beam (submerged cover only)
2
Align the slats for assembly. They
2
should be held at a 110°C angle.
5
Continue clipping the slats together
5
using the mallet. Slide your finger along
the join behind the mallet as you advance to
check that the slats are correctly clipped
together. If you encounter a bump, stop; pull
the 2 slats apart slightly and pass the screw
driver to facilitate assembly, then continue
with the operation.
Connecting the slats to the axle (except Thermodeck, slats are connected to the axle in the factory)
"Click"
3
6
aligned. Misalignment can break the plastic
tab.
Adjust such that the counterweight is suspended 2 cm above the pit floor
50/76
2009/02 - Indice de révision : D - code : 0035431
3
Press down to start clipping.
6
Finish clipping the slats together
checking that the slats are perfectly
Ø 250 mm axles: slide the
straps under the metallic
plates and tighten the screws.
when the cover is rolled out.