EUROM TH1800S 333978 Manuel D'utilisation page 20

Remote control
The remote control for the patio heater works on 2 batteries (1.5V
AAA). The battery compartment in the remote control is located at the
back. Slide it open, install the batteries (+ to +, - to -) and close the lid.
Point the remote control towards the sensor on the patio heater during
use. If there are obstacles between the remote control and the sensor,
it won't work!
Only use non-rechargeable batteries. Remove the batteries if the
heater is not to be used for a while as this will extend the lifespan of the
remote control. Replace empty or leaking batteries and dispose of them
with chemical waste. The chemical substances in batteries should not
come into contact with the skin or eyes or be swallowed. If this happen,
consult a doctor immediately.
Working
 Only use the terrace radiator on a steady, sound, flat and fully horizontal floor. The
entire surface of the base must be in contact with the floor.
 Only use the patio heater outside or in a large open area. Keep all flammable objects
such as tarpaulins, umbrellas, branches, furniture, curtains, paper, etc. away from the
appliance (at least 1 meter, even when they are blown up!).
 Before confirming, check that the minimum safety distances from the environment at
the chosen location are respected. The distance between the bottom of the radiator
and the floor must be at least 1.8 meters. The distance between the top of the radiator
and the ceiling, roof, etc. must be at least 0.3 meters. But if the ceiling or roof consists
of combustible material (for example tent canvas), at least 1 meter. There must be at
least 0.5 meters of space on both sides of the device from, for example, walls, etc.
 If you place the unit outdoors, make sure it is not exposed to direct wind.
 Always provide good ventilation
 Check for every use:
- or the appliance doesn't show signs of damage.
- or the socket you want to use gives the correct tension (230V-50Hz) and is earthed.
If everything is all right you can insert the plug into the socket. Press the main switch to
ON (I depressed) – the blue light on the control panel will start to flash. By now pressing
the ON button of the remote control or the control box, the emitter will start to work. The
blue light will be lit continuously. You switch the emitter off by pressing one of the OFF
buttons.
Now press the main switch to OFF (O protruding) and take the plug out of the wall socket.
Allow the radiator to cool down.
When you use the appliance for the first time (or after a long time again), observe it
during the first 10 till 15 minutes to be sure that is works trouble-free. When you have
been using the device for some time the colour of the glass surface of the heating element
may change to white in patches. This is normal and does not have any effect on the
performance or life span.
20