Niko 65-410 Mode D'emploi page 78

65-410
- Maximum wire diameter per terminal:
- power supply and load: 2 x 2,5mm
- input: 2 x 2,5mm
- Minimum load: 100W
- Maximum load: 1400VA resistive, inductive and capacitive (t<35°C)
- Maximum voltage drop across dimmer: -5%
- Protections: - electric thermal protection (105°C) with automatic restart (Light is reduced to
set minimum. It the temperature does not fall, the load is switched off).
- single thermal overload protection (135°C)
- Complies with standards EN60669-2-1 and EN55015
- Maximum distance to last push button: 100m.
- Max. output voltage: supply voltage x 0,95 (dissipated power = max. 1% of the absorbed power
= max. 14W)
- Wiring of analogue control
- Control and power circuits of the dimmer are galvanically isolated.
- The control inputs of the dimmer comply with the requirements for safety extra low voltage
(SELV). If the control signals originate from appliances that also meet the SELV requirements, no
specific requirements in terms of wire diameter or insulation of the control wires apply. In that
case, the control wires must be kept away from 230V~ lines (min. 10mm.). In all other cases
the SELV guarantees do not apply.
78
or 1 x 4mm
2
or 1 x 4mm
2 2
ε
R,L,C
2
EN