Niko 65-410 Mode D'emploi page 69

65-410
- Use the 'select' key or the 'control' key to set the desired minimum intensity. Keep the key pressed to
dim up to 40% or down to 1%. To reverse the dim direction, release and immediately press the key
again. When the desired intensity has been reached, release the 'select' key or the 'control' key.
> 2s.
prog
* = This is also possible with the 'control' key instead of with the 'select' key.
To save the settings and exit the programming status: press the 'programming' key > 2s. For
other settings, see § D.
D. Setting maximum 'max'
To move from 'min' to 'max' in programming status, briefly press the 'programming' key.
The section 'max' is used to set the maximum dim intensity. The maximum dim intensity can adopt
any value between 60% and 100%.
To set the maximum dim intensity, proceed as follows (see following diagram):
- Go to the section 'max' of the programming status: LED 'max' blinks.
- Use the 'select' key or the 'control' key to set the desired maximum intensity. Keep the key pressed
to dim up to 100% or down to 60%. To reverse the dim direction, release and immediately press the
key again. When the desired intensity has been reached, release the 'select' key or the 'control' key.
> 2s.
prog prog
* = This is also possible with the 'control' key instead of with the 'select' key.
To save the settings and exit the programming status: press the 'programming' key > 2s. For
other settings, see § A
EN
< 2s.
prog
< 2s. < 2s.
prog
< 2s.
prog
release and keep pressed = dim down
< 2s.
prog
release and keep pressed = dim down
ε
R,L,C
*
select
lang drukken
keep pressed = dim up
= opdimmen
loslaten en terug lang drukken
= neerdimmen
*
select
keep pressed = dim up
lang drukken
= opdimmen
loslaten en terug lang drukken
= neerdimmen
69