Niko 65-410 Mode D'emploi page 75

65-410
During normal operation, the 'input' LEDs can indicate the following:
LED Status
0-10V 1-10V
Neither LED is lit.
0-10V 1-10V
Upper LED lights steadily.
0-10V 1-10V
Lower LED lights steadily.
0-10V 1-10V
Both LEDs light steadily.
5. TROUBLESHOOTING
- Possible causes of dimmer malfunction:
- mains voltage not connected
- load not connected
- No control signal
- defective lamp
- thermal protection activated
- combination of above causes.
- The dimmer is provided with thermal protection. If the temperature runs up too high, the dimmer
is switched off (check whether the load is not too high). The dimmer automatically switches on
again as soon as the temperature has fallen sufficiently.
EN
Meaning
current mode of operation: 0-10V analogue control
current mode of operation: 1-10V analogue control
current mode of operation: single push button control
current mode of operation: double push button control
ε
R,L,C
75