Niko 65-410 Mode D'emploi page 67

65-410
In programming status, the 'mode' LEDs can indicate the following:
LED Status
100...1400VA
100...1400VA
Upper LED blinks.
100...1400VA
100...1400VA
Lower LED blinks.
100...1400VA
100...1400VA
Both LEDs blink.
To save the settings and exit the programming status: press the 'programming' key >2s. For other
settings, see § B.
B. Selection of operating mode 'input'
In programming status, briefly press the 'programming' key to move from the 'mode' section to the
'input' section. The 'input' section is used to select the mode of operation. To select one of the 4
modes of operation, you proceed as follows (see also the following diagram):
- Go to the 'input' section of the programming status: LED 'input' blinks.
- Briefly press the 'select' key to select the next mode of operation.
The selection of one of the different modes of operation is indicated by the associated 'input' LEDs
(see following diagram).
> 2s.
prog prog
EN
Meaning
100...1400W
Selection of: 'manual reversed phase control' (suitable for capaci-
tive, resistive and mixed loads)
100...1400W
Selection of: 'manual phase control' (suitable for inductive
loads)
100...1400W
Selection of: 'automatic'
< 2s.
select
ε
R,L,C
select
select
select
67