Cleaning - Muller licht Tint 404043 Mode D'emploi

Integration in a Zigbee gateway:
•
Start the search in the corresponding app.
•
Only now switch on the tint product (in pairing mode), even if this is
specified differently in the app.
•
The tint product is found by the app within a few seconds and flashes
briefly for confirmation. Depending on the app, the search takes a
few seconds after which the tint product is displayed in the app as a
new device and can be named as required.
A separate connection procedure must be carried out for each tint
product. To avoid problems, turn off all other tint products while
pairing a new tint product to the app.
The tint remote control can also be integrated in some Zigbee gateways,
so that LED bulbs and remote control can be used in parallel. Instructions
and further information can be found at www.mueller-licht.de/tint

Cleaning

Turn off the light and pull out the power plug and/or turn off the room
protection at the fuse box.
Clean the bulb and remote control only with a dry cloth. If not in use, keep
them in a dry place protected from children.
tint LED-PANEL
INSTRUCTION MANUAL
70