Muller licht Tint 404043 Mode D'emploi page 65

you will be able to use the groups later using the group button quickly
and without having to waste time testing them.
Using the group button
• The first time the group button is pressed, the LEDs above it will show
which group you are in.
• Pressing it again will advance you one group.
• You are in the next group when the following LED above the group button
lights up:
° LED 1 for the first group
° LED 2 for the second group
° LED 3 for the third group
° LED 1, 2 and 3 for all groups
Adding a new tint product
• Take note of the technical specifications when purchasing new tint pro-
ducts. We recommend tint tint bulbs and luminaires from Müller-Licht.
When using products made by other manufacturers, it is not guaranteed
that all features will be supported or will work as intended.
Integrate each product in the remote control one at a time and turn
off the others during the connection.
1. Plug the new tint product in at the mains and set the corresponding
light switch to I or ON.
The new tint product will signal that it is in coupling mode by briefly
increasing and decreasing its brightness and changing color if appli-
cable. If this does not occur, switch the product off and on again 5 times
(see „Resetting the tint product")
tint LED-PANEL
65 INSTRUCTION MANUAL