Installing The Led Panel - Muller licht Tint 404043 Mode D'emploi

fig. 1

Installing the LED panel

See illustrations on page 76
1. Before installing, de-energise the mains wiring: Switch off the circuit brea-
ker, or remove the fuse and secure to prevent reactivation.
2. Use the wall bracket to mark the holes to be drilled in the ceiling.
Make sure not to drill any cables or pipes in the area.
Drill at the marked points and insert the dowels. Now fasten the bracket
with the corresponding screws.
3. Connect the connection cable to the terminal strip in the connection box.
Make sure that the cables are secure, and close the connection box.
4. Install the panel as shown in the following illustration. For easier installati-
on, use the supplied wire rope to fix the panel during the wiring.
5. Slide the LED panel onto the fixed bracket.
6. Reactivate the breaker.
tint LED-PANEL
61 INSTRUCTION MANUAL
fig. 2 fig. 3