Muller licht Tint 404043 Mode D'emploi page 66

2. Press the group button repeatedly until all the LEDs above the group button
light up.
3. Hold the tint remote control very close (< 5 cm) to the new tint product (or to
its radio controller).
4. Hold down the group button until the tint product begins to blink.
The feedback display will first blink red evenly; then, it will begin to blink more
quickly.
This means that the tint remote control has found a signal.
Continue to hold down the group button until the new light flashes 3 times to
indicate that it has been connected to the tint remote control.Keep holding
down the group button until the tint product blinks again one time, which
shows that it has been assigned to default group (=group 1).
5. If desired, you can select a different group by repeatedly pressing the group
button (middle LED = group 2 etc.).
After approx. 10 seconds, the new tint product will be added to the selected
group and the feedback display will stop blinking. Wait this long, not pressing
any buttons during this time.
The procedure will then end and you can use the extended group as normal.
Remove a tint product from the tint remote control
1. Switch the tint product off (to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button.
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired tint product by pressing the group button repeatedly. The
tint product will signal that it has been selected by increasing and decreasing
its brightness. The tint product will blink in the order in which they are stored
in the tint remote control.
tint LED-PANEL
INSTRUCTION MANUAL
66