Reset - Muller licht Tint 404043 Mode D'emploi

Reset

Reset to 100% light
The tint light bulbs and luminaires can be easily reset by light switch to the
basic setting of warm white and 100% brightness. This may be necessary, for
example, if you have dimmed the tint products before and the remote control's
batteries are empty. This feature may also be used in the normal case if you do
not have the tint remote control on hand.
1. Use the light switch to switch the tint product off and on again 3 times
(interval: 1 second on, 3 seconds off).
2. The tint product will now start in its basic setting, warm white, 100%.
Resetting the tint product
Resetting the tint LED Panel is only required in exceptional cases, such as
when the remote control has had to be reset or when you want to integrate
the LED Panel into a smart home gateway.
1. Switch the tint product on and off 5 times (interval: 1 second on, 3 se-
conds off).
2. Switch the tint product on again. Depending on the tint product, a short
cycle through the colors appears or the tint product flashes briefly. The
reset has occurred as desired. Wait for 10 seconds, afterwards, you can
connect the LED-Strip to a tint remote control and/or a Zigbee gateway as
described above.
Resetting the tint remote control
A reset will only be required in exceptional cases, such as when the tint
product no longer responds to the tint remote control after removing and
reinserting the batteries.
tint LED-PANEL
INSTRUCTION MANUAL
68