Muller licht Tint 404043 Mode D'emploi page 67

5. Hold down the standby button for approx. 5 seconds. The tint product will then
signal that it has been removed from the tint remote control by flashing and
then dimming.
Shift a tint product from one group into another group
1. Switch the tint product off (to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button. (If you would
like to add a tint product from group 2 to group 1, for example, press the group
button repeatedly until the middle LED above the group button lights up).
3. Hold down the group button for approx. 5 seconds. The feedback display will
blink red/green.
4. Select the desired tint product by pressing the group button repeatedly. The
tint product will signal that it has been selected by increasing and decreasing
its brightness. The tint products will blink in the order in which they are stored
in the tint remote control.
5. Hold down the group button again until the selected tint product starts to blink
again.
The group display for group 1 will also light up.
6. Using the group button, select (if necessary) the group to which you would like
to add the tint product while the feedback display still is blinking red/green.
The selected bulb will be assigned to default group (=group 1) if group button
is not pressed at all. After approx. 10 seconds, the tint product will be added to
the selected group and the feedback display will stop blinking. Wait this long,
not pressing any buttons during this time.
The procedure will then end and you can use the extended group as normal.
tint LED-PANEL
67 INSTRUCTION MANUAL