magnetic MALLET Mode D'emploi page 94

Immunity test Immunity test
Conducted RF Conducted RF
IEC 61000-4-6 IEC 61000-4-6
Radiated RF Radiated RF
IEC 61000-4-3 IEC 61000-4-3
Note 1: at 80 MHz and 800 MHz, the higher frequency range applies Note 1: at 80 MHz and 800 MHz, the higher frequency range applies
Note 2: these guidelines may not apply in all situations. Electromagnetic propagation is affected by Note 2: these guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people. absorption and reflection from structures, objects and people.
30 30
INGLESE.indd 30 INGLESE.indd 30
IEC 60601 Test level IEC 60601 Test level
3 Vrms 3 Vrms
150KHz to 80MHz 150KHz to 80MHz
3V/m 3V/m
80 MHz to 2,5 GHz 80 MHz to 2,5 GHz
Compliance Compliance
level level
environment - guidance environment - guidance
Portable and mobile RF communication Portable and mobile RF communication
equipment should be used no closer to equipment should be used no closer to
any part of the device, including cables, any part of the device, including cables,
than the recommended separation than the recommended separation
distance calculated from the equation distance calculated from the equation
applicable to the frequency of the applicable to the frequency of the
Recommended separation distance. Recommended separation distance.
d=1,167* sqrt (P) 80 MHz to 800 MHz d=1,167* sqrt (P) 80 MHz to 800 MHz
d=2,2333* sqrt (P) 800 MHz to 2,5 GHz d=2,2333* sqrt (P) 800 MHz to 2,5 GHz
3 Vrms 3 Vrms
Where P is the maximum output power Where P is the maximum output power
rating of the transmitter in watts (W) rating of the transmitter in watts (W)
according to the transmitter according to the transmitter
manufacturer and d is the manufacturer and d is the
3 V/m 3 V/m
raccomended separation distance raccomended separation distance
Field strengths from fixed RF Field strengths from fixed RF
transmitters, as determined by an transmitters, as determined by an
electromagnetic site survey electromagnetic site survey
should be less than the compliance should be less than the compliance
level in each frequency range. level in each frequency range.
Interference may occur in the vicinaty of Interference may occur in the vicinaty of
equipment marked with the following equipment marked with the following
Electromagnetic Electromagnetic
transmitter. transmitter.
d=1,167* sqrt (P) d=1,167* sqrt (P)
in metres (m). in metres (m).
3 3 , ,
b b
symbol: symbol:
05/05/15 16:31 05/05/15 16:31
Th Th
ra ra
Th Th
by by
eq eq
m m
F F
s s
th th
tr tr
N N
N N
a a
INGL INGL