Installation And Connection - magnetic MALLET Mode D'emploi

7.2. Installation and connection

7.2. Installation and connection
Warning: Install the device in dry environments only. Take care no liquid Warning: Install the device in dry environments only. Take care no liquid
gets into the control unit. gets into the control unit.
Caution: The device should be installed and kept away from the patient. Caution: The device should be installed and kept away from the patient.
The power source and the Magnetic Mallet should have the same nominal volt- The power source and the Magnetic Mallet should have the same nominal volt-
age. The nominal voltage is indicated on the rating panel placed on the rear panel age. The nominal voltage is indicated on the rating panel placed on the rear panel
of the control unit. of the control unit.
2. Connect the power cable (H) to the device through the socket (A) 2. Connect the power cable (H) to the device through the socket (A)
3. Plug in the power cable (H) of the device 3. Plug in the power cable (H) of the device
4. Jack in the proper handpiece (O) into the connector (M) 4. Jack in the proper handpiece (O) into the connector (M)
5. Jack in the footswitch (L), into the connector (N) 5. Jack in the footswitch (L), into the connector (N)
Caution: Prior to the activation, take sure you've plugged in the proper Caution: Prior to the activation, take sure you've plugged in the proper
handpiece according to the required use/treatment. handpiece according to the required use/treatment.
18 18
INGLESE.indd 18 INGLESE.indd 18
QUANTITA' QUANTITA'
1 1
DISEGNATO DISEGNATO
TCR TCR
Questo document Questo document
pubblicazione, div pubblicazione, div
MACCHINA MACCHINA
GRUPPO GRUPPO
NUMERO DISEGNO NUMERO DISEGNO
05/05/15 16:30 05/05/15 16:30 INGL INGL