WAGNER W 860 E Mode D'emploi page 22

GB
•
Ensure that no solvent vapors are sucked in by the unit. Do not spray onto the unit!
•
The spray gun is not a toy; children must therefore not be allowed to handle it or play
with it.
•
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
may transport paint mist over great distances and cause damage.
•
The units may only be used with a functional valve.
hose (Fig. 12 A, item 14) do not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
overheating. In this case, turn off the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air filter,
slots for air intake covered.
With original WAGNER accessories and spare parts, you have the guarantee that all
safety regulations are fulfilled.
Max. viscosity
Max. flow rate
Power source
Power consumption
Atomizing output:
Double insulation
Sound pressure level
Oscillation level
Air hose length
Weight
1) Air cap
3) Union nut
5) Trigger guard
7) Gun handle
9) ON/OFF switch
11) Carry handle
13) Bottom section
15) Closure
17) Gun holder
19) Ventilating hose
21) Fastener for radiator/detail spray
attachment (accessory)
23) Cover of air filter compartment
25) Cable grommet
27) Air hose retainer
16
not to be sprayed. When working keep in mind that wind, for example,
Technical Data
170 DIN-s
240 g/min
230 - 240 V
570 W
130 W
80 dB (A)
< 2,5 m/s
3,5 m
5,7 kg
Description (Figs. 1+2)
If paints rises in the ventilating
~
TechnDat_GB
2) Tip
4) Standard spray attachment
6) Material volume regulation
8) Air volume control
10) Air hose
12) Cover
14) Main switch
16) Container
18) Valve
20) Air hose connection
22) Deposition tray for hardware
24) Air filter
26) Power cable
28) Deposition tray for spray attachments
W 860 E
Beschreibung_GB