Displaying The Temperature In °C / °F; Moon Phase; Displaying Summertime; Setting The Timer - Auriol IAN 311178 Instructions D'utilisation Et Consignes De Sécurité

Displaying the temperature
in °C / °F
The current indoor air temperature
on the LCD.
Press the °C / °F button
the Celsius and Fahrenheit temperature scales.

Moon phase

The product shows the current moon phase
the LC display.
It uses the following symbols:
Full moon Waning
gibbous
New moon Waxing
crescent

Displaying summertime

Summertime is automatically indicated on the LCD by
the summertime icon
the information as to whether it is summertime or
not from the DCF radio signal.
Note: Reception of the radio signal may be seriously
disrupted in reinforced concrete buildings.
is indicated
7
to switch between
20
in
8
Last quarter Waning
crescent
First quarter Waxing
gibbous
. The product receives
6

Setting the timer

Press and hold the °C / °F button
prox. 3 seconds. The Timer symbol
will be displayed.
Press UP button to change the values for
25
hours and DOWN button
values for minutes.
Hint: If you press and hold down the UP or
DOWN, you accelerate the process and reach
the desired value more quickly.
Press the WAVE button
The timer now begins counting down and the
Timer symbol
You can press the WAVE button again
anytime to stop the timer from counting down.
Press the WAVE button again to continue the
count down.
When the set time has elapsed, a signal tone
will sound for a period of one minute.
Press the WAVE button to stop the signal tone
from sounding.
Press the ALARM ON / OFF button
the timer back to 00:00.
Press and hold °C / °F button
3 seconds to return to the normal time display.
Note: The maximum countdown time is
19 hour and 59 minutes!

Troubleshooting

This product has delicate electronic components.
This means that if it is placed near an object
that transmits radio signals, it could cause inter-
ference. If the display indicates a problem,
move such objects away from it.
Electrostatic discharges may cause malfunctions.
In the event of such malfunctions, remove the
batteries briefly and reinsert them or press the
RESET button at back of the product.
30
Note: All setting will be clear once the batteries
are removed. Or the RESET button
been pressed.
for ap-
20
2
to change the
24
to start the timer.
19
is flashing.
2
to reset
29
for approx.
20
have
30
GB/IE/NI 11