Renson Cube Manuel page 129

5
6
hold ■ for 3 seconds or simultaneously tap ▼ and ▲.
You can also use the Installer menu 'Connect fan' to connect a second TouchDisplay to one and
the same fan. Shortly press the 'LINK' button on the main pcb of the Cube and press update link
on the second TouchDisplay (use menu 'Connect fan').
If the connection was successful then both TouchDisplays can be used to control the Cube.
If two TouchDisplays are connected to 1 fan then one needs to be set as main control and the
other as secondary control. Use the Installer menu 'Device settings – main controller'
(see section 9.1.3.3.6 B).
The following screen appears when the connection has been
successful.
The following screen appears when the connection was
unsuccessful. Repeat the previous procedure.
(if a connection is established with a previously installed fan,
the number of connected fans will not be adapted).
In order to leave the Installer menu 'Connect fan',
Cube
®
EN
129