Renson Cube Manuel page 114

Cube
®
EN
It is possible to manually adapt the ventilation level during the automatic mode by pressing ▲ or ▼.
To indicate that the chosen ventilation level differs from the preconfigured ventilation program, the
program point will be coloured red. The ventilation level will switch back to the program when the
next program point (1-8) is reached.
The blue blocks on the control indicate the current ventilation level.
There is a visualization if the ventilation level is adapted because of
the demand controlled regulation:
2
A green block is added
to the blue ones and the
program point will colour red
when a higher ventilation
level is needed than the pre-
programmed one due to a
rise in CO .
2
• Manual mode
114
3
If a higher ventilation level is needed than the pre-programmed
one due to a rise in relative humidity or presence, extra blue
blocks will be added (the number of blocks always indicates
the level of ventilation intensity L1-L4) and the program point
will colour red.
You can manually set the ventilation rate in the manual mode (L1
to L4). The ventilation will disregard any program points and the
demand controlled regulation will not be active.
The ventilation level can be changed by pressing ▲ or ▼.