Renson Cube Manuel page 121

9.1.3.3 • Installer menu (for the installer)
The Installer menu allows you to alter the operating parameters of the ventilation system.
We strongly advise NOT to change these parameters after the ventilation system has been
calibrated by a skilled and qualified installer. Changing these parameters can influence the
proper functioning of the ventilation system. Ask your installer for advice.
Main control mode
1
• To access the Installer menu you need to access the User menu
(hold ■ for 3 seconds or simultaneously tap ▼ and ▲).
• If you hold ▼ and ▲ for 3 sec in the 'User menu', you will access the 'Installer menu'.
The following parameters can be adjusted in the Installer menu:
– Ventilation levels
– CO threshold
2
– Connect remotes
– Connect fan
– Device settings
– Factory reset
– Signal strength
– Device information
• Use ▼ and ▲ to choose between the different Installer menus and each time confirm with ■.
User menu
2
Cube
Installer menu
3
®
EN
121