Know Your Product; Operation - SPARKY BR2 7.2Li HD Notice Originale

During the charging process the charger and bat-
tery might become warm. This is a normal condi-
tion, and does not indicate a problem.
▪ After completion of charging which takes ap-
proximately 30 min, the red LED ceases to glow
and the green LED lights up.
The charger features thermal overload protection
for the battery. Nevertheless we recommend with-
drawing the battery from the charger upon expir-
ing of the charging time. You may use additionally
an electric timer in order to control the charging
time.
TO OBTAIN THE BEST LIFE FOR THE
BATTERY
▪ When battery is not in use, keep it away from
other metal objects like paper clips, coins, keys,
nails, screws, or other small metal objects that
can make a connection from one terminal to
another. Shorting the battery terminals together
may cause fire or explosion.
▪ Always unplug the charger when not in use and
store in a dry secure place.
▪ Do not charge battery packs and do not store
the charger in premises where the temperature
may drop under 0ºC or exceed +40ºC.
VII - Know your product
Before using the power tool, familiarize yourself
with all operating features and safety require-
ments.
Use the tool and accessories only for the applica-
tions intended. All other applications are expressly
ruled out.
1. Keyless chuck
2. Speed selector switch
3. Forward/reverse switch
4. Battery release buttons
5. Battery
6. ON/OFF trigger switch
7. LED light
8. Torque adjustment collar
9. Charger
10. LED charge state indicator
VIII - Operation
LED WORK AREA LIGHT
The machine is equipped with LED light (7) to il-
luminate the work area and improve visibility when
8
EN
pages BR2-7.2LiHD.indd 8
drilling in areas with insufficient light. To turn the
LED light on and off depress the LED light but-
ton (6).
REVERSING
The extreme position of lever (3) to the right (viewed
from the rear) is equivalent to anti-clockwise rotation,
the extreme position to the left - to clockwise rotation.
When the ON/OFF switch (6) is depressed lever (3)
can not be actuated. (Fig. 2)
WARNING: Reversing can be performed
only when the spindle is not rotating!
Drilling and tightening screws are performed with le-
ver in extreme position to the left. Removal of screws
is performed with lever in extreme position to the
right.
SWITCHING ON - SWITCHING OFF
Switching on: press ON/OFF switch (6).
Switching off: release ON/OFF switch (6).
The power tool is equipped with a brake. The spin-
dle stops rotating immediately after releasing the
switch lever.
SMOOTH ELECTRONIC RPM CONTROL
Light pressure on ON/OFF trigger switch (6) re-
sults in low rotation speed, further pressing the
switch results in smooth increase of the rpm to
maximum upon reaching the extreme position.
ADJUSTING THE TORQUE
Rotate the torque adjustment collar (8) behind the
chuck, to adjust the torque to each of 19 settings.
The range of 19 torque settings allows better con-
trol when using the drill as a screwdriver thus pre-
venting over-tightening of the screws.
The numbers circling the collar are used to indi-
cate the level of torque. The larger the number on
the collar, the higher the torque. To select any of
the numbers, rotate the collar (8) until the desired
number aligns with the arrow head indicator on
the housing of the machine.
Screwdriving
Set the torque adjustment collar (8) against
one of 19 positions.
Select low setting range for working with
small screws or in soft materials.
Select high setting range for working with
large screws or in hard materials.
BR2 7.2Li HD
9.11.2011 . 09:43:13 .