Checchi & Magli TEXDRIVE BEST Manuel D'utilisation Et D'entretien page 94

Replacing the flexible plate
D
A
UN41-0446AM
For this operation, proceed as outlined below.
1) Loosen the wing nut (A).
2) Turn the lock lever (B).
3) Push the share forwards and turn it so it is facing
downwards.
4) Release the springs (C).
5) Unscrew the screws (D).
6) Remove the flexible plate (E).
7) Fit the new flexible plate in position.
8) Tighten the screws (D).
9) Hook up the springs (C).
Scrapping the work vehicle
Scrapping operations must be handled by specialised
personnel with suitable skills for the job.
English language
INFORMATION CONCERNING REPLACEMENTS
F
C
10) Make sure the flexible plate is centred (see "Adjust-
11) Check the position of the flexible plate with respect
12) Tighten the screws (D).
13) Refit the share in the work position.
14) Make sure that the share is secured in place with the
15) Tighten the wing nut (A).
Check that the Plant Control device (F) is inside the
share.
The components removed must be sorted according to
the type of materials they contain and in compliance
with the laws in force concerning "waste collection, sort-
ing and disposal".
44
E
ing the flexible plate centring").
to the share (see "Adjusting the flexible plate posi-
tion").
lock lever (B).
Information
8
B
Use and maintenance