Checchi & Magli TEXDRIVE BEST Manuel D'utilisation Et D'entretien page 78

Adjusting the dispensing/ejection timing
When the plant falls into the ploughshare (C), the ejector
(B) should be in the rear position and should then start
pushing the plant to eject it.
C
UN41-0430AM
For adjustments, proceed as outlined below.
1) Remove the pin (A).
2) Remove the lid (D).
3) Loosen the screws (E).
4) Turn the dispenser clockwise to speed up the ejec-
tor's pushing action or rotate the dispenser anticlock-
Adjusting the opening of the dispenser cups
Depending on the type of seedlings and on the rotation
speed, when the seedlings go down the dispenser they
may knock the side of the opening of the drop pipe and
fall in way which is not perpendicular.
UN41-0455AM
For adjustments, proceed as outlined below.
1) Loosen the screw (A).
2) Turn the cam (B) in the direction (1) to anticipate the
opening of the cup.
English language
ADJUSTMENT INFORMATION
B
28
Adjust the correct phase between the dispensing unit
and the ejector according to the different planting
speeds.
wise to delay the pushing action.
The notches on the dispenser allow accurate timing
adjustment.
5) Tighten the screws (E).
6) Place the lid (D) on the dispensing unit.
7) Insert the plug (A).
Adjust the opening of the cups to release the seedling in
the centre of the drop pipe.
1
2
B A
3) Turn the cam in the direction (2) to postpone the
opening of the cup.
4) Tighten the screw (A).
5
D A
E
Use and maintenance