Checchi & Magli TEXDRIVE BEST Manuel D'utilisation Et D'entretien page 73

Adjusting the flexible plate position
A
UN41-0428NL
For adjustments, proceed as outlined below.
1) Loosen the wing nut (A).
2) Turn the lock lever (B).
3) Push the share forwards and turn it so it is facing
downwards.
4) Loosen the nut (C).
5) Turn the screw (D) as required to position the flex-
ible plate (F) flush with the ploughshare (G), as
shown in the figure.
Adjusting the row spacing
Danger - Warning
Secure the work vehicle in position (lifted off the
ground) with external means (trestles, etc.).
Do not stand under the hoisted machine unless it is
suitably secured in position.
English language
ADJUSTMENT INFORMATION
E
6) Tighten the nut (C).
7) Refit the share in the work position.
8) Check that the Plant Control device (E) is inside the
share.
9) Make sure that the share is secured in place with the
lock lever (B).
10) Tighten the wing nut (A).
Adjust the gap between the planting units to obtain
the row spacing required (for distances envisaged, see
"Technical characteristics").
Keep the minimum distance stated on the illustration
between the seedlings and the tractor wheels.
23
B
F
G
Use and maintenance
5