Checchi & Magli SP 140 Manuel D'utilisation Et D'entretien page 56

Checking the gear box oil level
Carry out the operations described.
1) Position the work vehicle (with the gear box level) on
flat ground in a risk-free area.
2) Switch off the tractor engine and remove the ignition
key from the dashboard.
3) Unscrew cap (A) and check that the oil is level with
the bottom edge of the hole.
4) If necessary unscrew the cap (B) and top up the oil to
the correct level.
5) Screw on the cap (A).
6) Screw on the cap (B).
For oil characteristics see the "Lubricant comparison ta-
ble".
Check of nuts and bolts tightening torque
Check the tightening torque of all nuts and bolts.
If the bolts are loose tighten them to the prescribed
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
English language
MAINTENANCE INFORMATION
B
A
UN41-0757CP
torque (see the "Nuts and bolts tightening torques
chart").
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication diagram").
22
7
Use and maintenance