Setting Surface Controls - KENMORE ELITE 970-6985 Serie Guide D'utilisation Et D'entretien

Setting Surface Controls

• Electronic Surface Element Controls (ESEC)
• Available ESEC Display Settings
• Hot Surface Indicator Lights
• Cooktop Sabbath Day Feature and Message (Sb)
• ESEC Lockout Feature (- -)
The Electronic Surface Element Control (ESEC)
The Electronic Surface Element Control ("ESEC") feature provides a digital
display of the radiant surface elements on the cooktop. The ESEC displays in
combination with the touch pads are designed to replace the conventional
control knob and power level tick mark indicators.
In addition your range includes shared radiant element touch pad settings.
The "Bridge" element combinations and Triple radiant element settings are
also shown in the ESEC display windows.
The available ESEC Window Display Settings
The ESEC control will display heat levels ranging from Hi (Fig. 1) to Lo (Fig.
6) and OFF (Fig. 7) that will display in the ESEC windows. The settings
between 9.0 (Fig. 2) and 3.0 (Fig. 3) decrease or increase in increments of .5
(1/2). The settings between 3.0 (Figs. 3 & 4) and 1.0 (Fig. 5) are Simmer
settings which decrease or increase in increments of .2 to Lo ( Fig. 6; lowest
Simmer setting) for more precise settings at lower heat levels. Use the
Recommended Surface Setting Chart (See page 11, Fig. 1) to determine the
correct setting for the kind of food you are preparing.
Hot Surface Indicator Lights
After using any of the radiant element positions the cooktop will become very
hot. After turning any of these elements OFF, the cooktop will remain HOT for
some time. The backguard control monitors the temperature for 5 positions on
the cooktop. The "Hot Surface" indicator light (Fig. 8) will glow whenever any
of the element positions becomes HOT. The Hot Surface indicator light will
remain ON while hot and turn OFF once the cooktop has cooled sufficiently
(Fig. 9).
ESEC PF message
The ESEC will display the PF message whenever there has been a power
interruption to the appliance. PF will appear in the ESEC display windows as
shown in Fig. 10. To clear the PF message touch any ON/OFF ESEC control
pad to reset and be sure to reset the clock with the correct time of day if
necessary. If the PF displays again repeat these steps.
Cooktop Sabbath Day Feature and (Sb) Message
The ESEC will display the Sb messages whenever the Sabbath Day feature is active (Fig. 11). When
activated, the Sabbath Day Feature works for both the oven and cooktop together. Once the Sabbath
Day Feature is active, changes to the heat levels for the cooktop elements will not show in the
displays. The cooktop will react slower to heat level changes. To set the Sabbath Day feature see the
complete instructions on page 32.
ESEC Lockout Feature ( - - )
The ESEC feature will not operate during a Self-Clean cycle or when the Oven
Lockout feature is active. Whenever the ESEC Lockout feature is active, " - - "
will appear in any display window (See Fig. 12. Also refer to the Oven Lockout
instructions on page 20).
All manuals and user guides at all-guides.com
10
Fig. 1
Fig. 3
Fig. 5
Fig. 7
Fig. 8
Fig. 10
Fig. 12
Fig. 2
Fig. 4
Fig. 6
Fig. 9
Fig. 11