Continuous Bake Or Twelve Hour Energy Saving Mode; Timer - KENMORE ELITE 970-6985 Serie Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Setting Oven Controls

Continuous Bake or Twelve Hour Energy Saving Mode

Timer

Setting Continuous Bake or 12 Hour Energy Saving
The TIMER
and FLEX CLEAN
oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left
on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking.
INSTRUCTIONS
To set the control for Continuous Bake or 12 Hour
Energy Saving features:
1. Press and hold
once. (Fig.1). "12h" or "- - h" will appear in the display and the
control will beep once.
2. Press
to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "12h" (See Fig. 2) in the
display indicates the control is set for 12 Hour Energy Saving
feature and "- - h" (See Fig. 3) indicates the control is set for
the Continuous Bake feature.
3. Press
to accept the change (See Fig. 4) display will
return to time of day or press
Setting Timer
The TIMER
pad controls the Timer feature. The Timer serves as an extra reminder in the kitchen that will beep when
the set time has run out. The Timer will not START or STOP the cooking process. The Timer feature may be used during
any of the other oven control functions. Refer to "Minumum & Maximum Control Pad Settings" section for time amount
settings.
INSTRUCTIONS
To set the Timer (example for 5 minutes):
1. Press
. (See Fig. 5).
2. Press the number pads to set the desired time in the display
(example
). Press
down. (See Fig. 6).
Note: If
is not pressed the timer will return to the time of
day.
3. When the set time has run out, the clock will sound with 3 long
beeps every 5 seconds until
To cancel the Timer before the set time has run out:
Press
. The display will return to the time of day.
All manuals and user guides at all-guides.com
pads control the Continuous Bake or 12 Hour Energy Saving features. The
for 6 seconds or until the control beeps
to reject the change.
. The timer will begin a count
is pressed (See Fig. 7).
PRESS
for 6 seconds
or
PRESS
19
DISPLAY
Fig. 1
Fig. 2
Fig. 3
Fig. 4
DISPLAY
Fig. 5
Fig. 6
Fig. 7

Publicité

Table des Matières
loading

Table des Matières