Transportation; Setting Up; Power Supply - CombiSteel 7054 Serie Mode D'emploi

TRANSPORTATION

Due to design, the appliance is suitable for transportation by forklift. Put the forks between braces of the
appliance. The gravity center is located in the middle of the housing, consider this point when transporting. Pay
attention to the balance when lifting the appliance.
transporting by hand. The gravity center is located in the middle of the housing.

SETTING UP


Set up the appliance on a level surface.

Provide the fixity via adjustable braces.

Make sure the appliance is set up properly when operatıng.

POWER SUPPLY


Make sure power supply connection is carried out by qualified personnel.

Make sure that the voltage of your power supply system suits appliance's electrical system.
Motor (kW)
RPM
Nominal phase
Voltage
Frequency (Hz)
Check the plate's direction of rotation. The direction of rotation must coincide with
Take necessary measures to prevent the overthrow of the appliance when
Do not transport the appliance by dragging along the ground.
7054.0005
7054.0025
M* 0,55
T** 0,55
1400
M ~ 1N
T ~3N
M 220
T 380
50/60
Table 3 – Motor Engine characteristics
an arrow sign on the cover. If the plate rotates in the opposite direction switch
The appliance is grounded by yellow/green cable.
www.combisteel.com
Models
7054.0010 7054.0015
7054.0030 7054.0035
1,1
1,1
1400
~ 1N
~3N
220
380
50/60
two-phased cable.
7054.0020
7054.0040
1,5 1,1
1,5 1,1
1400 900
~ 1N ~ 1N
~3N ~3N
220 220
380 380
50/60 50/60
7