Publicité
Les langues disponibles
Les langues disponibles
E-ISM Boxer
6.6
Adjust trigger and lock
X
Ensure that the wire cable is not pinched.
When adjusted correctly, the disc and the notch must be aligned.
X
Check that the release slide is still engaged. The gap between retaining disk and the mark should be 1–5 mm.
(1.) (see figure A).
X
Check that the release slide is still engaged. The gap between retaining disk and the mark should be 1–5 mm
(2.) (see figure B).
6.7
Positioning the function saveguard of the integrated closing sequence control
X
Close the fixed leaf (1.).
X
Connect the sliding lever with the sliding pad of the moving leaf. (2.) (tightening torque: 5 Nm).
X
Pull out the driver (3.).
X
Release the screws of the tamper-proofing device, max. 1/2 turn (4.).
X
Pull out the stop bar (5.).
à Distance edge of lock and stop bar approx. 30 mm.
X
Open the closing time valve „1" at the moving leaf (6.).
X
Close the moving leaf (7.).
The stop bar for the tamper-proofing device has been positioned.
X
Open the moving leaf (8.).
X
Tighten the screws of the tamper-proofing device (9.).
CAUTION
Stop bar must not be pass under the driver.
Mounting and securing
Fig.: 6.6.1
Fig.: 6.7.1
GB 7
Publicité
