KTM Power Parts 90505979000 Mode D'emploi page 9

11
12
14
15
15
16
17
C
Preparatory work 125/200 Duke + RC
Removing the original main silencer
- Remove screws (11) and (12) on the left.
- Remove the right screw (13).
13
- Remove screw (14) and pull out the fixing bolt.
- Loosen flange nuts (15).
- Lower the rear of the motorcycle to be able to remove the original main
silencer (16).
NOTE:
Secure the motorcycle in the lowered position with a lashing strap if necessary.
The lashing strap may damage the seat and plastic parts.
Protect susceptible parts with padding.
- Remove the original main silencer (16).
- Remove the lashing strap.
125/200 Duke only
- Remove screws (17) and the passenger footrest unit (Figure C).
- Drill holes (18) with a 6.5-mm diameter and cut an M8 thread (Figure D).
18
NOTE:
Cut the thread deep enough. If necessary, check using the screws M8x16
(included).
- Position the footrest unit and mount it with the original screws (26 Nm).
18
D