KTM Power Parts 90505979000 Mode D'emploi page 11

Final steps
Make sure that the silencer is not touching any other parts of the motorcycle.
Remove all grease residue with a soft cloth sprayed with multi-purpose lubricant (Motorex Joker 440).
Cleaning prevents stains from baking onto the surface. Do not use aggressive chemical cleaners as they may damage the label.
Test the function of the brakes and suspension. Make sure that all screws are tightened. If the exhaust system is touching the trim or
other parts, readjust the unit or contact your authorized dealer.
When the exhaust system is first put into operation, it is normal for white smoke to be emitted by the silencer. Finally, check for leaks
in the whole exhaust system.
Do not stand behind the exhaust when it is being used for the first time.
- Mount the exhaust springs (25) (included in kit B).
A
24
- Align the entire exhaust system and tighten all screws.
B
25
When using the main silencer for the first time, the engine rpm must be kept
low for roughly the first 5 minutes to evenly heat the main silencer. This ensu-
res that the rock wool will reach its full effectiveness and will keep the volume
down to the required level.
25 B
Finishing work RC 125/200
- Remove screws (26).
26
- Remove the exhaust cover.
26
- Adjust the bug spoiler with workshop equipment.
- Install the adjusted bug spoiler in reverse order.
The adapter for the lifting equipment (61029955244) cannot be installed
on the right side in combination with the AKRAPOVIC main silencer– Danger
of collision between the adapter and the main silencer.
The rear crash pads (90110945000) cannot be installed on the right side
in combination with the AKRAPOVIC main silencer– Danger of collision
between the crash pads and the main silencer.