Internal Webserver Access - Power One AURORA PVI-AEC-EVO Guide D'installation Rapide

PVI-AEC-EVO / PVI-AEC-EVO LIGHT
QUICK INSTALLATION GUIDE
L.

Internal Webserver access

In order to access to the Webserver pages of the system, after having done the connection of the system to the local
network LAN or direct connection to the PC, open an internet browser (e.g. Internet Explorer) and type into the
address bar the following address:
Note: To access the webserver pages it is necessary to insert a username and a password:
After having done the access to the internal Webserver, go to the configuration page (CONFIG) of the system
(PLANT) and insert the installation GPS coordinates according to one of the following formats:
Latitude N43.33
Longitude E11.35
Latitude 43N50'20"
11E23'30"
Longitude
*
The Double Quotation Mark ( " ) symbol must be inserted by entering twice the quotation mark ( ' ) symbol.
Note: To set the GPS parameter is mandatory to assure the proper working of monitoring system.
http://<system IP address>
USERNAME: admin
Indicator Degrees
N
E
Degrees Indicator
43 N
11 E
17 - EN
PASSWORD: admin
Point
43 .
11 .
Minutes Quotation Mark
50 '
23 '
Degrees (Hundredths of degree)
33
35
Seconds Double quotation
20 "
30 "
mark*