Configuration Of The Analog Inputs - Power One AURORA PVI-AEC-EVO Guide D'installation Rapide

PVI-AEC-EVO / PVI-AEC-EVO LIGHT
QUICK INSTALLATION GUIDE
After carrying out these checks, start up first the monitoring system and then the inverters. The system automatically
carries out a scan of the RS485 bus and automatically detects the available inverters.The presence of the inverters can be
checked directly from the display.
1. Enter the main menu as administrator (See par.'C').
2. Access the 'CURRENTVALUES' > 'ENERGY INVERTERS'
'ENERGY RACK' (to display the 55kW conversion modules). The number of inverters detected during the scan will be
displayed;the list of the monitored inverters identified by the Serial Number (S/N) can be displayed by scrolling using
the arrow keys (
PVI-AEC-EVO ......
12.00.00 01/01/11
>CURRENT VALUE
SETTINGS
>ENERGY INVERTERS
ENERGY RACK
>ENERGY RACK
ENERGY PLANT
Note: The time necessary for the PVI-AEC-EVO to scan and acquire the inverters depends on the number of
inverterspresentonthesameline(sometimesseveralminutes).
H.

Configuration of the Analog Inputs

The connection of the analogue sensors must be carried out respecting the pin-outs of the J3 connector.
The system has two 0-10Vdc inputs and a PT100/1000 input.
Note: To each analogue input (both 0-10Vdc and PT100/1000 types) it is possible to connect only one analog
sensor. Itisthereforenotpossibletoconnectmultiplesensorsonthesameanaloginput.
With respect to the connection of the PT100/1000 sensors,the system is able to carry out the sensor reading through the
connection of three-wires:
l
A sensor power supply line (PT_ALIM);
l A reading line (PT_SENSE);
l A power supply and reading closing line (PT_RTN).
).
menu pin
0***
ENTER
ENTER
>INVERTER SN 123456
ENTER
>RACK
ENTER
menu (to display the string inverters) and/or
30 INVERTERS
RACK N. 1
SN 123456
11 - EN
'CURRENTVALUES' >
SET PIN TO 0010
NEXT
ENTER
CHANGE VALUE
DIGIT
CHANGE
INVERTER
CHANGE
RACK