Power One AURORA PVI-AEC-EVO Guide D'installation Rapide page 18

CHANGETHE PVI-AEC-EVO NETWORK PARAMETERS
:in order to change the PVI-AEC-EVO network parameters,please follow the procedure below:
1. Power on the system and wait for the start up phase to complete (Ref.Par.'E').
2. Enter the main menu as administrator (Ref.Par.'C').
3. Access the menu "SETTINGS" > "NETWORK"
Subnet mask, Gateway) may be modified using the items of the
system for connection to the LAN network and/or for direct connection to a PC.
4. At the end of the setting operations, return to the main screen, then switch off and switch on the system to
make the settings take effect.
PVI-AEC-EVO ......
12.00.00 01/01/11
>settings
change password
>NETWORK
SET DATA
>IP method
ip setting
>IP SETTING
SUBNET MASK
>SUBNET MASK
ip gateway
>IP gateway
ip method
Monitoring System
. The parameters for connection to the LAN network (IP address,
menu pin
0***
ENTER
>datalogger
io settings
ENTER
ENTER
>IP method
manual
ENTER
>IP SETTING
XXX.XXX.XXX.XXX
ENTER
>subnet mask
XXX.XXX.XXX.XXX
ENTER
>IP gateway
XXX.XXX.XXX.XXX
ENTER
16 - EN
"NETWORK" menu.This allows to configure the
SET PIN TO 0010
CHANGE VALUE
ENTER
CHANGE
METHOD
CHANGE VALUE
CHANGE VALUE
CHANGE VALUE
NEXT
ENTER
DIGIT
ENTER
NEXT
ENTER
DIGIT
NEXT
ENTER
DIGIT
NEXT
ENTER
DIGIT