Power One AURORA PVI-AEC-EVO Guide D'installation Rapide page 20

In order to allow the PVI-AEC-EVO to communicate with the Aurora Vision web portal,access the configuration page
(CONFIG) of the network (NETWORK) and check that in section 'DATA TRANSFER', under item 'IP Address Portal'
there is the IP address 63.236.63.180
Note: If the setting 'IP Portal Address' does not correspond to 63.236.63.180, change it by entering the
above-mentioned address and press 'Confirm' to activate it. After this operation, reset the system
(ON-OFF).
Note: To make the system fully functioning it is essential that the same system is constantly connected
to the internet so that it is able to communicate with the Power-One server. This is essential to
graphically shows the data on web pages as well as for sending alarm and/or report messages.It is
essential that the LAN network in which the PVI-AEC-EVO is wired is such that it allows the
connection to the IP address 63.236.63.180 to be reached through port 80, so that the
PVI-AEC-EVO is able to communicate with the portal management server.
Monitoring System
.
18 - EN