Firmware Updating - Power One AURORA PVI-AEC-EVO Guide D'installation Rapide

PVI-AEC-EVO / PVI-AEC-EVO LIGHT
QUICK INSTALLATION GUIDE
O. Firmware updating procedure via SD Card
It is possible to upgrade the firmware of the PVI-AEC-EVO either locally using the SD Card, or remotely using the web
portal AuroraVision.
Note: The firmware update via SD card should be carried out
viatheAuroraVisionwebportal
Note: For details on the procedure for the firmware updating through the web portal Aurora Vision, refer
to the documentation on the website
1. Access the display by entering the user password 0000.
2. Check and note the current firmware versions installed:
Firmware AVR:
Firmware Display:
Firmware IO:
3. Turn off the PVI-AEC-EVO and wait at least one minute.
4. Disconnect all available connections from the PVI-AEC-EVO (RS458 line(s),LAN connection,sensors).
5. Remove the SD Card from the slot on the PVI-AEC-EVO front panel by pressing the SD Card gently.
6. Insert the SD Card into the SD Card reader or into to the SD Card reader slot of the PC.
7. Delete the folders upgrade,web,lang and config from the SD Card.
8. Copy the new folders upgrade,web,lang and config into the root of the SD Card.
9. Remove the SD Card from the SD Card reader or from the SD Card reader slot.
10. Insert the SD Card into the slot on the PVI-AEC-EVO front panel by pressing the SD Card gently to lock it into place.
11. Turn on the PVI-AEC-EVO and wait about one minute.(N.B.: Power failure during update may cause serious damage
to the device).
12. Enter the display by pushing the ENTER button and insert the password"0010";push ENTER to confirm.
13. Follow the path: "SETTINGS > UPGRADE FIRMWARE > UPGRADE AVR"
upgrade (few minutes).After the upgrade the system will reboot:wait the complete reboot (date/time will be shown
on the display).
14. Enter the display by pushing the ENTER button and insert the password"0010";push ENTER to confirm.
15. Follow the path "SETTINGS > UPGRADE FIRMWARE > UPGRADE ADC"
upgrade (few minutes). The upgrading process will be completed when the message
displayed.
.
www.Auroravision.net
Information > Product > Firmware AVR
Information > Product > Firmware Display
Information > Product > Firmware IO
21 - EN
only if it is not possible to update the firmware
.
press ENTER to confirm;wait the completing of
press ENTER to confirm;wait the completing of
"Upgrade Success" will be