Introduction; Contents Of The Package; Contents Of This Instruction Manual; Typographical Conventions - Videotec MDI Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1 Introduction

1.1 Contents of the package

• 1 MDI Dome
• 1 instructions manual
• 1 Mounting-plate
• 1 Pigtail Break-out cable
• Mounting hardware (4 x screws & wall plugs, 2 X feed- thru feet)
When the product is delivered make sure the package is intact and has no obvious signs of dropping, scrapes
and scratches. If the package is damaged contact the supplier immediately.

1.2 Contents of this instruction manual

This manual describes the MDI Dome, with its specific procedures for installation, configuration and use.
Before installing and using the dome, read this manual carefully, especially the section concerning the

safety rules.

1.3 Typographical conventions

This manual makes use of different graphics symbols, the meaning of which is described as follows:
Hazard of electric shock; disconnect the power supply before proceeding, unless specified otherwise.
Please read the procedure or information shown, and if necessary carry out the instructions in the way.
Failure to carry out the procedure correctly could lead to faulty operation of the system or damage it.
Read carefully to understand system operation.
2 Safety rules
The MDI dome complies with the legislation and standards in force, at the time of this manual's
publication, with regard to electrical safety, electromagnetic compatibility and general requirements.
Nevertheless, for the safety of the user (installer technician and operator) the following warnings are
specified to ensure completely safe operation:
• The device (and the complete system to which it belongs) must only be installed by a skilled, authorised
technician.
• Tampering with the device will invalidate the guarantee.
• Connect the system devices to a power supply line corresponding to the one shown on the respective data
plates (see the following section Identification data).
• Before moving or carrying out any technical operations on the device, disconnect the power supply jack
• The device can only be considered off-line when the power supply jack is disconnected and the cables
connected to other devices have been removed.
• Do not use extension cables showing signs of wear or aging, since they are extremely hazardous for the
user's safety.
• This product is designed for indoor use only and it must not be installed where exposed to rain and moisture
• Do not use the device in the presence of inflammable substances.
• Make sure the device is always resting on a sufficiently large, solid base.
• For after-sale service call only authorised staff.
• Keep this manual carefully for future reference.
Pag. 3
MNVCMDI_0419

Publicité

Table des Matières
loading

Table des Matières