Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
The diagram below summarises the controls managed by the control unit and the priority of these controls.
PRESENCE 220
LED's
Rain/wind sensor triggering LED
This LED is normally OFF and lights up to signal that the rain and wind sensor has been triggered. It
remains ON as long as the sensor is enabled.
Alarm LED
This LED is normally OFF and lights up to signal that the smoke detector, which automatically opens the
window, has been triggered.
When this LED lights up, there is a continuous buzzer signal and the remote alarm output is enabled
until the system is reset. This function has absolute priority over all the other commands.
12
ON
RF
Alarm
memory
(Reset)
ON
ON
ON
ON
CONTROLS
CE
PV2
RV
SP
Thermostat
Centralised
open/close
button
é é é é ê ê ê ê Panel
buttons
NO 220 V
WITH BUFFER
BATTERY INSTALLED
ON
ON
One movement only. In alarm:
closing memory of 135 sec. (with
priority)
You can select the opening
time. Open/close reverse delay
of 135 sec. Does not have
priority during the delay.
Maintained/spring-ret. logic
Time set 150 seconds
Publicité
