Admissible Lamps - Robert Juliat 900 SNX Dossier Technique

Projecteurs de decoupes msr 1200/2500w reamorcage a chaud

Masquer les pouces

Table Des Matières

Table des Matières

Manufacturer's recommendations:

• Read attentively the manufacturer's instructions.

• Positioning of the lamp and connecting of the power supply require great care. To make sure there is a good

conduction of current, the mechanical support and the electrical connections must be free form dirt and corrosion.

The clamps and brackets must be checked whenever the lighting unit has been transported.

• The lamp emits ultraviolet radiation. Direct exposure can be harmful to your health.

• It is recommended to avoid air draughts, also avoid exposing the lighting unit to bad weather.

• Use only when bulb in place

Technical characteristics:

Nominal absorbed voltage...............................................................1200Watts

Voltage use: European standard ........................................ 230/245 Volts 50H

Voltage use: North American standard .....................................208 Volts 60Hz

Minimum voltage of the power supply .............................................. 198 Volts

(Below this charge = ignition failure is possible).

Voltage at the terminals of the lamp .................................................. 100 Volts

Amperage at the terminals of the lamp ...........................................13,8 Amps

Luminosity of the lamp .................................................................. 110 000 L's

Luminous effectiveness ..................................................................... 91 Lm/W

Colour temperature ....................................................................... 6000 Kelvin

Base.......................................................................................................... G 38

Manufacturer's rated life ................................................................. 1000 hours

User's precautions:

• The lamplife, as given by the manufacturer, is a theoretic lamplife duration as "in laboratory conditions",

a cycle based on 3 hours on / 1 hour off. Briefer cycles reduce the duration of the lamplife.

• In operating conditions, it is uncommon for the lamp to be still working after 200 to 300 hours. Its efficiency

can decrease by 30%.

• Premature wearing of lamp under performing conditions is mainly due to frequent switching on. Better leave

the lamp on, through the performance, rather than switching it on repeatedly. ( The lamplife is reduced about

1 hour, each time the lamp is switched on ). It is advised to wait for 10 minutes before switching on again.

(This extends the duration of the lamp.)

• Use over 500 hours of the lamp : change the lamp even if it still lights up.

New lamp:

• To achieve a good ionization of a new lamp, when using it for the first time, it is recommended to leave it on

for a few hours.

• Preserve carefully the guarantee slip of the lamp, as it may be asked for in the event of a dispute.

robert juliat

Route de Beaumont F 60530 Fresnoy-en-Thelle - phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr

TECHNICAL FILE

1200W & 2500W MSR PROFILES