Jacuzzi Designer Directives D'installation & D'utilisation page 2

• Suction cover must be in place at all times to minimize the potential for hair and body entrapment.
• Keep body and hair a minimum of 6" away from suction fitting at all times when the whirlpool system is operating. Hair longer than shoulder
length should be secured close to the head.
• Never operate electrical appliances (hairdryer, telephone, television, radio etc.) inside or within 5 feet of the bath.
• Never leave small children unattended in the bath.
• Do not operate the whirlpool system unless the bath is filled with water to at least 2" above the highest jet.
• Do not use oil-based bath additives in your whirlpool bath.
• When cleaning your bath, do not use abrasive substances which will damage the bath's surface.
• A maximum water temperature of 104°F is recommended. Bathing at temperatures above 104°F for prolonged periods can be injurious to
health.
• To prevent discoloration of the acrylic finish, do not fill the bath with water in excess of 140°F.
WARNING: When using this unit, basic precautions should always be followed, including the following:
Read and follow all instructions.
DANGER: to reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all times.
Use this unit only for its intended purpose as described in this manual. Do not use attachments not recommended by the manufacturer.
Never drop or insert any object into any opening.
Do not operate this unit without the suction cover in place.
This unit must be connected only to a supply circuit that is protected by a ground fault circuit interrupter (GFCI). Such a GFCI should be provided
by the installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset
button. Power should be restored. If the GFCI fails to operate in this manner, there is a ground current flowing, indicating a possibility of an
electric shock. Do not use this unit. Disconnect the unit and have the problem corrected by a qualified service representative before using.
A pressure wire connector is provided on the exterior of the motor to permit connection of an No. 8 AWG (8.4 mm) solid copper bonding conductor
between this unit and all other electric equipment and exposed metal in the vicinity, as needed to comply with local requirements.
WARNING: When using electrical products, basic precautions should always be followed including the following:
DANGER: RISK OF ELECTRIC SHOCK. Connect only to a circuit protected by a ground fault circuit interrupter.
Grounding is required. This unit should be installed by a qualified service representative and grounded.
(For built-in and custom units.) Install to permit access for servicing.
SUMMARY OF PRECAUTIONS
IMPORTANT SAFETY INSTRUCTIONS