Troubleshooting - Alutech LG-600F-868 Manuel D'installation Et D'utilisation

TROUBLESHOOTING

in this manual, instructions for other involved devices, and following the safety rules. Perform
scheduled maintenance at least once every six months.
Scheduled maintenance shall include:
• check the wear of the set elements, paying attention to oxidization of the components.
Replace all parts and units with an unacceptable degree of wear. Use original parts from
the manufacturer.
• Check the correctness of the door stop in its final positions. If necessary, reprogram the
final positions.
• Clean external surfaces of the drive and safety devices. Clean with the help of a soft moist
cloth. The use of the following for cleaning is forbidden: water jets, high pressure cleaners,
acids and alkali.
• Perform the check according to the instruction in section 7. 'Testing and commissioning' .
Y
The manufacturer does not perform direct control of the mounting of the door, drive and
automation devices, their maintenance and operation, and cannot be responsible for the
safety of the drive system mounting, operation and maintenance.
9. TROUBLESHOOTING
Y
In case of a failure, which cannot be repaired, based on the information provided in this
manual, consult the service department. Information about the service department can be
obtained from your supplier (vendor, installation company).
Drive does not work
(ALUTECH logo on the drive
is not lit; display does not react,
when buttons on the front plate
are pressed)
Drive is not controlled by the
remote control (indicator on the
control is not lit)
Drive is not controlled by the
remote control or the distance
of the remote-control operation
is small
Drive works after a command, but
the door does not move
Door does not stop in final
positions
Drive does not react to obstacles
on the optical axis of photocells
during door operation
LEVIGATO DRIVES (LG SERIES)
fAULT
No supply voltage or fuse
is blown
Remote control code is not
recorded in the drive control
unit memory
Low battery in remote control
The drive rail carriage is not
blocked
Final positions have changed
due to abnormal situation
Photocells are malfunctioning or
the incorrect operating mode of
the photocells is selected
| LEVIGATO ANTRIEBE (SERIE LG)
POSSIBLE REASON
| COMMANDES LEVIGATO (SERIE LG)
RECOMMENDATIONS
Check the supply voltage.
Check, and if necessary, replace
the fuse (fuse parameters should
comply with the marking)
Record the remote control in the
drive memory
Check the remote-control battery
and replace, if necessary
Block the drive rail carriage
When an obstacle is found, the drive
will independently specify the final
positions during next opening based
on the support, installed on the rail
Check the performance of
photocells, replace, if necessary;
check the selected photocells mode
in the menu
Table 8
29