Adjustment - Alutech LG-600F-868 Manuel D'installation Et D'utilisation

ADjUSTMENT

6. ADjUSTMENT
The adjustment of the drive is performed using the board with buttons
A display is used for indication (fig. 30).
P1—SETTING THE DOOR POSITION
P1–F1—Setting the final positions
1
The OPEN and CLOSED positions are set
manually
Press and hold
1.1
for about 5 secs to enter the
programming mode
Using and
1.2
select program 'P1' on the
menu
1.3 Press
Using and
1.4
select function 'F1' on the
menu
1.5 Press
Using or
set the door in the OPEN
position.
ATTENTION!
1.6
In the OPEN position the
carriage rail should be at
a distance ~ 20 mm from
the support; installation of
support is compulsory
1.7 Press ; after that a dot
will appear on the display
Using or
set the door in the CLOSED
position.
ATTENTION!
1.8
Avoid excessive pressing
of the door leaf against the
doorway in the CLOSED
position
LEVIGATO DRIVES (LG SERIES) | LEVIGATO ANTRIEBE (SERIE LG)
Press ; after that a dot
will appear on the display.
1.9
ATTENTION!
Automatic movement of the
door begins immediately
The door automatically moves
1.10
to the OPEN position
The door automatically
moves to the point of contact
1.11
between the carriage rail and
support
The door automatically
1.12
returns to the OPEN position
The door automatically moves
1.13
to the CLOSED position
After completion of all
positional settings of the
door, 'F1' inscription will
1.14
appear, to exit the setup
menu press
or wait for 15 seconds
P1–F2—Setting the 'pedestrian' position
Setting the PEDESTRIAN position (can be used as
2
the VENTILATION position): command can only
be set from the remote-control board
Press and hold
2.1
for about 5 secs to enter the
programming mode
Using and
2.2
select program 'P1' on the
menu
2.3 Press
Using and
2.4
select function 'F2' on the
menu
| COMMANDES LEVIGATO (SERIE LG)
Table 6
or twice
19