Alutech LG-600F-868 Manuel D'installation Et D'utilisation page 22

ADjUSTMENT
2.5 Press
Set the door in the
PEDESTRIAN position
2.6
or
2.7 Press ; after that a dot
will appear on the display
To exit the menu, press
2.8
three times or wait
for 15 seconds
P1–F3—Express setup
The OPEN and CLOSED position is set
3
automatically, then the remote controls are
recorded into the memory in the 'step-by-step'
mode
Simultaneously press and
hold and
~ 5 secs.
ATTENTION!
Automatic movement of the
3.1
door begins immediately.
Note: the express-setup pro-
cedure can be initiated similar
to item 1.1 ... 1.5 of Table 6, if
program 'P1' and function 'F3'
are selected
The door automatically moves
to the contact point between
the carriage rail and the
support, and a dot appears on
the display.
3.2
ATTENTION!
The OPEN position of the
carriage rail will be located
at a distance ~ 20 mm from
the support; installation of
support is compulsory
The door automatically moves
to the CLOSED position.
ATTENTION!
3.3
Movement continues to the
upper panel support), and
after that a dot appears on
the display
The door automatically moves
3.4
to the OPEN position
20
for
LEVIGATO DRIVES (LG SERIES)
The door automatically moves
3.5
to the CLOSED position
'rc' is shown on the display,
which means that the
3.6 recording of remote controls
in 'step-by-step' mode is
expected
Press the selected control
3.7 button on the remote control
three times
The indicator will
automatically show the
number offered for a remote
control in the drive memory
3.8
(the number can be changed
using buttons
Press
3.9
after that a dot will appear
on the display
In one second the automatic
switch to the recording of
the next remote control will
take place.
3.10
To exit the programming
mode press
times or wait for 15 seconds
P1–F4—Periodic control of end positions
The function is designed to monitor and adjust
4
the end positions once every 100 cycles of raising
and lowering the gate
Press and hold
4.1
for about 5 secs to enter the
programming mode
Using
4.2
select program 'P1' on the
menu
4.3 Press
Using
4.4
select program 'F4' on the
menu
4.5 Press
| LEVIGATO ANTRIEBE (SERIE LG)
and
to confirm;
three
and
and
| COMMANDES LEVIGATO (SERIE LG)