Alutech LG-600F-868 Manuel D'installation Et D'utilisation page 28

ADjUSTMENT
P7–F4—Setting the 'safety margin'
31
mode / method
Enter the programming mode
(similar to items 1.1–1.5 from
31.1
Table 6). Select program 'P7'
and function 'F4'
'no. ' —'safety margin' is off,
'01. ' —'resistive safety margin'
8.2 kOhm,
31.2
'02.'—optical sensors.
Default value—'no. '
P7–F5—Setting 'safety margin' and photocells
blocking close to the floor level
This function is used to operate the drive with
32
safety devices (photocells etc.), automatically
protruding into the opening when the leaf is
moving
Enter the programming mode
(similar to items 1.1–1.5 from
32.1
Table 6). Select program 'P7'
and function 'F5'
'no.'—'safety margin'
blocking is off,
'01 ... 99.'—distance from
floor, at which 'safety
32.2
margin' is blocked, value
'99' corresponds to distance
~ 200 mm from the floor.
Default value—'no. '
P8—SETTING SIGNAL LAMP AND LIGHT LAMP OPERATION MODES
P8–F1—Setting the continuous operation
mode of signal lamp
This option allows setting of the continuous
33
signal lamp power supply when the door is
moving, or in interrupted manner
(to ensure 'flicker' of the signal lamp)
Enter the programming mode
(similar to items 1.1–1.5 from
33.1
Table 6). Select program 'P8'
and function 'F1'
26
LEVIGATO DRIVES (LG SERIES)
'no. ' —'continuous operating
mode of the signal lamp is off
(signal lamp will 'blink' during
work);
33.2
'on. ' —'continuous operating
mode of the signal lamp is on.
Default value—'on.'
P8–F2—Setting the time of signal lamp
preliminary activation
This option allows to set the operation of
34
a signal lamp in such manner, that it signals the
beginning of door movement by a set number
of seconds
Enter the programming mode
(similar to items 1.1–1.5 from
34.1
Table 6). Select program 'P8'
and function 'F2'
'00 ... 10'—time of the
preliminary activation of
a signal lamp before the door
moves;
'00'—corresponds to
immediate movement of the
34.2
door;
'10'—corresponds to the time
of preliminary activation of
10 secs.
Default value—'00. '
35 P8–F3—Illumination activation duration setup
Enter the programming mode
(similar to items 1.1–1.5 from
35.1
Table 6). Select program 'P8'
and function 'F3'
'no.'—illumination is off after
door movement stops,
'01 ... 99.'—light lamp
activation duration time,
'01'—corresponds to 5 secs,
'99'—corresponds to
35.2
~ 500 secs (~ 8 min 20 secs).
Default value is '06' , which
corresponds to 30 secs of
light lamp work after drive
movement stops
| LEVIGATO ANTRIEBE (SERIE LG) | COMMANDES LEVIGATO (SERIE LG)